Eltako Wireless actuator PWM dimmer switch for LED FWWKW71L

PWM dimmer switch with 2 channels for LED 12-36 V DC, each up to 4 A. Input: two terminals each for + and -. Output: one terminal for +, two terminal each for channel 1 (warm white) and channel 2 (cold white). Adjustable minimum brightness and dimming speed. With snooze function and light alarm circuit.

Gateway KNX ENO 626 secure

The KNX ENO 626 secure device serves as a bidirectional gateway between EnOcean wireless devices and the KNX bus. With this device, commands and measured values from EnOcean wireless sensors can be transmitted to the KNX bus, for example to control KNX actuators. EnOcean wireless actuators can also be controlled via KNX. The KNX ENO

Eltako Wireless window touch contact with energy generator pure white FFTE-rw

48 x 32 x 11.5 mm. Also for ­monitoring of doors, drawers and other mobile equipment. Generates the power for wireless telegrams when the button is pressed. Therefore, no connecting wire and no standby losses. A wireless telegram is sent when a window is opened or closed. For more than 100,000 switching cycles. Evaluated via

Eltako Wireless window handle sensor, 120 x 35 x 7 mm, with battery ­(lifetime 7 years) FFG7B-

Installation behind conventional window handle. Wireless transmit telegrams for window positions open, tilted and closed. Status telegram every 15 minutes. Very simple installation under standard window handle: Unscrew handle, fit sensor, and screw handle back on. In individual cases, the square pin of the window handle is too short when using the FFG7B- and can

Thermostat-EST.1

Various EEP optional Support underfloor heating, ventilation, air conditioning control system Able to install battery Built in solar cell 55*55 German standard frame Matched with gateway, it can control underfloor heating, ventilation, air conditioning at the same time Without gateway, it can control underfloor heating, ventilation, air conditioning independently. Air conditioner types and ventilator gears

Two Channel Dimmer – RPL.D2-1A

Two-way CMOS dimmer, each can drive the loop 1 a current load. Better dimming effect than conventional SCR. You can set the maximum and minimum values for different lamps.

EnOcean to TCP/IP Gateway

The EnOcean to TCP/IP Gateway creates a powerful connection between devices on EnOcean protocol or TCP/IP Network. This WIFI gateway( IEEE 802.11b/g/n Compatible) can Learn numerous EnOcean devices, such as wireless switch, occupancy sensors etc. Any device with EnOcean protocol can easily be connected with this LD-Gateway and controlled and managed remotely through a mobile

Wireless CO2 Sensor

The LD-CO2/A is designed to measure and report levels of Carbon Dioxide, ambient temperature and relative humidity. During normal operation, the sensor is powered from ambient room light: in prolonged low light environments ensures continued operation for over 4 days of maintenance free operation. This Wireless CO2 Sensor will send telegrams automatically the sampling rate

Wireless CO Sensor

The LD-CO/A is designed to measure and report levels of Carbon Monoxide and ambient temperature. The sensor is powered from ambient room light or line power: in prolonged low light environments ensures continued operation for over 4 days of maintenance free operation. This Wireless CO Sensor will send telegrams automatically the sampling rate is 10

Li-SOCl2 Battery Occupancy Sensor

The occupancy sensor with long-life Li-SOCl2 battery is designed for accurately detecting when an area (no enough light) is occupied or not. This device is wireless, powered by the internal battery or line power, and uses a passive infrared (PIR) sensor to detect motion for transmits RF signals to control lighting, curtain and other devices