Omnio flush-mounted thermostat actuator 2-channels UPH230/12

The Omnio flush mounted thermostat actuator UPH230/12 is a device to regulate control valves in floor heatings or similar electric loads through a two-point controller with hysteresis. Each of its two potential free outputs are able to be controlled by an Omnio room sensor RTF and up to eight Omnio window contacts or –handles in AND-operation. The room sensor transmits temperature and setpoint to the thermostat actuator by radio. The desired room temperature can be set on the room sensor using the control buttons, but it can also be specified by a higher-level system. Various operating modes such as night setback can be selected via Omnio radio transmitters. If the temperature falls below 8 °C or if the room sensor is defective, the frost protection function is automatically activated. Bidirectional communication, EEP D2-34-01. ARCO ready (AWAG Remote Commissioning).In addition, this actuator can be used as repeater in case of range issues. Suitable for flush mounted sockets.

  • Product No. 3412 000
  • Manufacturer AWAGhttp://www.awag.ch/
  • Category Actuator / Relay Receiver, Receivers & Controllers
  • Frequency 868MHz (ASK): EU (and potentially others e.g. Non-EU Europe, China, Singapure…)
  • RX-EEP D2-34-01
  • Certification Certified Level 2

Downloads