Omnio flush-mounted multi thermostat actuator 1-channel UPH230/10
The Omnio flush mounted multi thermostat actuator UPH230/10 is a device to regulate control valves in floor heatings or similar electric loads through a two-point controller with hysteresis. Its potential free output is able to be controlled by an Omnio room sensor RTF and up to eight Omnio window contacts or –handles in AND-operation. The room sensor transmits temperature and setpoint to the thermostat actuator by radio. The desired room temperature can be set on the room sensor using the control buttons, but it can also be specified by a higher-level system. Various operating modes such as night setback can be selected via Omnio radio transmitters. If the temperature falls below 8 °C or if the room sensor is defective, the frost protection function is automatically activated. A conventional push-button at the extension input can be used to switch over to the second setpoint. Bidirectional communication, EEP D2-34-00. ARCO ready (AWAG Remote Commissioning). In addition, this actuator can be used as repeater in case of range issues. Suitable for flush mounted sockets.
- Product No. 3410 000
- Manufacturer AWAGhttp://www.awag.ch/
- Category Actuator / Relay Receiver, Receivers & Controllers
- Frequency 868 MHz (ASK): Europe, China
- RX-EEP D2-34-00
- Certification Certified 2.0