e.g. USA, Canada

wiSTAR Occupancy Sensor Wall Mounted

Saving energy without sacrificing comfort can be effortless with occupancy based controls. Hubbell Building Automation’s wiSTAR Wall-Mounted Occupancy Sensors are wireless and self-powered making them one of the most cost-effective ways to control energy-use in unoccupied rooms.

wiSTAR Rocker Pad (single, double) Self-powered, Wireless Switch

Self-powered wireless controls are simple to install. Hubbell Building Automation’s wiSTAR Single and Double Rocker Pads use EnOcean energy harvesting technology to communicate wirelessly with other wireless devices and provide convenient control of lighting, temperature and miscellaneous electric loads.

2-Gang Self-powered Wireless Light Switch

The 2-Gang Self-powered Wireless Light Switch allows two, three or four light switches to be installed at one location. Further information

wiSTAR Plug-in Switch Module

A simple solution for wireless control through any standard outlet. Controlling lamps and electronics in any room is simple when you use Hubbell Building Automation’s wiSTAR Plug-In Switch Module.

Dual Rocker Wireless Light Switch

Self-powered wireless light switch with dual rocker. Each rocker transmits a different RF signal allowing control of two separate loads from one location. Further information

Hotel Key Card Reader

The new ILLUMRA wireless Key Card Reader automates hotel room energy conservation by disabling HVAC and lighting in unoccupied rooms. The device installs in minutes without wires or batteries, minimizing installation, clean-up and downtime costs. Further information

wiSTAR Self-Powered Wireless Light Sensor With Optional Occupancy Detection

Hubbell Building Automation’s wiSTAR Wireless Light Sensor has built-in solar cells that draw on available ambient light to power itself and can operate for up to 7 days in total darkness.

Single Rocker Wireless Light Switch

Control one light or one group of lights with the Single Rocker Wireless Light Switch. Further information

4 Channel Contact Input Interface

The Echoflex Contact Input Interface offers four wired inputs to interface with Echoflex wireless control devices. Each input has two terminals (+5V, Input) for interfacing with almost any equipment creating a hybrid control solution.

4 Channel Contact Output Interface

The Echoflex Contact Output Interface offers four dry contact outputs to interface with third party devices and control systems. Each output can be set up individually, linked to one or many wireless switches or sensors based in standard profiles.