Eltako Wireless window handle sensor, 120 x 35 x 7 mm, with battery ­(lifetime 7 years) FFG7B-

Installation behind conventional window handle. Wireless transmit telegrams for window positions open, tilted and closed. Status telegram every 15 minutes. Very simple installation under standard window handle: Unscrew handle, fit sensor, and screw handle back on. In individual cases, the square pin of the window handle is too short when using the FFG7B- and can

Thermostat-EST.1

Various EEP optional Support underfloor heating, ventilation, air conditioning control system Able to install battery Built in solar cell 55*55 German standard frame Matched with gateway, it can control underfloor heating, ventilation, air conditioning at the same time Without gateway, it can control underfloor heating, ventilation, air conditioning independently. Air conditioner types and ventilator gears

Two Channel Dimmer – RPL.D2-1A

Two-way CMOS dimmer, each can drive the loop 1 a current load. Better dimming effect than conventional SCR. You can set the maximum and minimum values for different lamps.

EnOcean to TCP/IP Gateway

The EnOcean to TCP/IP Gateway creates a powerful connection between devices on EnOcean protocol or TCP/IP Network. This WIFI gateway( IEEE 802.11b/g/n Compatible) can Learn numerous EnOcean devices, such as wireless switch, occupancy sensors etc. Any device with EnOcean protocol can easily be connected with this LD-Gateway and controlled and managed remotely through a mobile

Wireless CO2 Sensor

The LD-CO2/A is designed to measure and report levels of Carbon Dioxide, ambient temperature and relative humidity. During normal operation, the sensor is powered from ambient room light: in prolonged low light environments ensures continued operation for over 4 days of maintenance free operation. This Wireless CO2 Sensor will send telegrams automatically the sampling rate is

Wireless CO Sensor

The LD-CO/A is designed to measure and report levels of Carbon Monoxide and ambient temperature. The sensor is powered from ambient room light or line power: in prolonged low light environments ensures continued operation for over 4 days of maintenance free operation. This Wireless CO Sensor will send telegrams automatically the sampling rate is 10 mins,

Li-SOCl2 Battery Occupancy Sensor

The occupancy sensor with long-life Li-SOCl2 battery is designed for accurately detecting when an area (no enough light) is occupied or not. This device is wireless, powered by the internal battery or line power, and uses a passive infrared (PIR) sensor to detect motion for transmits RF signals to control lighting, curtain and other devices

Solar powered Occupancy Sensor

The occupancy sensor with solar powered by indoor light is designed for accurately detecting when an area is occupied or not. This device is wireless, Obtain energy from light and stored , and uses a passive infrared (PIR) sensor to detect motion for transmits RF signals to control lighting, curtain and other devices more efficiently.

Wireless temperature and humidity sensor

Wireless and maintenance free temperature and humidity sensor (optical) with a small pre-installed solar cell, an internal energy harvester. If energy storage fully charged, it can work 4 days in total darkness. When wake up, a radio telegram will be transmitted in case of a significant change of measured temperature or set point values or

Wireless Magnet Contact

LD-MC is a wireless magnet contact. Powered by a solar cell, it works absolutely maintenance-free. An integrated energy store allows operation for several days even in total darkness. The reed contact housing and the magnet housing are very small. This means that the magnet contact is unobtrusively mountable at every window frame made of aluminum,