USB-Gateway SG-USB300

The gateway SG-USB300 serves as bidirectional gateway between Omnio and computer systems with a USB interface. This gateway is equipped with the EnOcean radio module TCM 300.

Omnio Gateway APG03B-RS485

The Omnio gateway APG03B-RS485 serves as bidirectional gateway between Omnio and computer systems with RS485 interface. It receives and transmits all valid EnOcean radio telegrams. The used protocol is completely open, which easily allows the integration in personal systems. Configuration is carried out via ARCO technology (AWAG Remote Commissioning) with the E-Tool Freeware. Suitable for

Omnio flush mounted push-button interface 2-channels TST230/10

The Omnio flush mounted push-button interface 2-channels TST230/10 is a binary input device to integrate wired push-buttons, switches and sensors into the Omnio radio system. Two potential free closing contacts may be connected to its inputs. Depending on the chosen evaluation (rocker-switch, push-button, time switch or weather station) the push-button interface transmits, repeats and additionally

Omnio Room Sensor RTF161

The Omnio room sensor RTF- 161 is a battery less, maintenance-free and wireless sensor to measure temperature (0…40 °C) and humidity (0…100 %rH) indoors. The temperature can be set with its operation elements (set point). It is able to transmit temperature, humidity and set point via radio to Omnio thermostat actuators and gateways. The RTF-

Omnio Room Sensor RTF160

The Omnio room sensor RTF- 160 is a battery less, maintenance-free and wireless sensor to measure temperature (0…40 °C) and humidity (0…100 %rH) indoors. The measured value is transmitted wireless to Omnio thermostat actuators and gateways. The RTF160 is characterised by its excellent long-term stability and thanks to the built in solar cell it is

Omnio flush-mounted multi switching actuator 2-channels UPS230/12

The Omnio flush-mounted multi switching actuator 2-channels UPS230/12 is a device for switching electrical loads. Its two potential free outputs are able to be actuated from up to 50 Omnio radio transmitters. Each transmitter can be programmed with one out of twenty different functions such as switch, push-button, staircase lighting, step-switch (AW20), time controlled switch

Omnio weather evaluation unit XFJ

The Omnio weather evaluation unit XFJ is able to convert the captured weather data into EnOcean telegrams. This way blinds can be pilot-controlled and protected against thunderstorms. The following individual signals are available: Channel 1: Weather raw data for higher-level systems according to EEP A5-13-01… 06. Channel 2: Alarm due to failure of the weather

CO2-Sensor

The CO2-sensor is a wired radio sensor to capture the concentration of carbon dioxide (400…2550 ppm) in the air. The measured values are transmitted wireless to Omnio gateways. It is particularly used to control the air quality indoors in offices, schools, hotels and residential premises. EnOcean Equipment Profile (EEP) A5-09-04.

Omnio blind cable actuator 1-channel KXJ230/12

The blind cable actuator 1-channel KXJ230/12 is a device to control 230 V~ tubular motors of blinds, sun blinds, awnings, sliding gates or garage doors. Its two interlocked outputs are able to regulate one drive and can be actuated from up to 50 Omnio radio transmitters. This allows the exact positioning of the blinds and

Omnio DIN rail mounted blind actuator 4-channels REGJ12/04

The Omnio DIN rail mounted blind actuator 4-channels REGJ12/04M is a device to control 230 V~ tubular motors of blinds, sun blinds, awnings, sliding gates or garage doors. Its eight potential free interlocked outputs are able to regulate four drives and these can be actuated from up to 50 Omnio radio transmitters. This allows the