TRIO2SYS – EnOcean dry contact sensor with assistance

EnOcean dry-contact transmitter module

The dry-contact transmitter is designed to detect changes in the status of all equipment with a potential-free, normally open (preferred) or normally closed dry-contact output.

It enables connection to the EnOcean protocol of all products with On/Off (ON/OFF) status reporting, where it is neither desirable nor possible to connect them by wire.

The sensor is fitted with a crimp connector (insulation displacement) that can be disconnected. The sensor is powered by a solar cell, making it maintenance-free. As soon as the dry contact changes state (open to closed or vice versa), a radio message is sent immediately. In addition, a message is sent back approximately every 15 minutes.

Self-sufficient, the necessary energy is generated by a solar cell that operates maintenance-free. An internal charger stores the energy, ensuring full operation even after several days of total darkness.

The 10020083 sensor’s built-in assistance system enables it to operate even in areas where light levels are too low to be recharged by the solar panel. When the sensor’s energy reservoir is insufficient to operate it, then the assistance takes over until the solar sensor is sufficiently lit again.

FUNCTIONS:

  • Dry contact sensor
  • Recovers the status of any device with a dry-contact output, and transmits the signal wirelessly using EnOcean technology.
  • Recovers the status of any ON/OFF device, and transmits the signal wirelessly using EnOcean technology.
  • Energy self-sufficient, maintenance-free
  • Supported by lithium battery

TECHNICAL SPECIFICATIONS

  • Antenna / transmission range: Internal propeller / 300m in open field, approx. 30m indoors (depending on conditions)
  • Power supply: Generated by a small solar cell (photovoltaic generator)
  • Frequency: 868.3MHz
  • Emission power: 10 mW max
  • Detection frequency: 0.5 Hz max
  • Detection current: 1μAmax
  • Dry contact resistance: Open 5MΩ min. – Closed 1KΩ max
  • Distance Equipment / Sensor: 1m max from sensor
  • Connector capacity, crimp wire section: from 0.2 to 0.32 mm2 (AWG 22/24), outside 1.3mm max.
  • Ambient temperature: -10°C to +60°C
  • Illumination: >100 lux average per day
  • Teach-in button: Internal push-button for teach-in operation
  • REED contact module dimensions: Base 78 x 25mm x height 15mm
  • Housing color: White ABS
  • Degree of protection: IP40

Downloads

TRIO2SYS – EnOcean dry contact sensor with assistance