Omnio Room Sensor RTF160

The Omnio room sensor RTF- 160 is a battery less, maintenance-free and wireless sensor to measure temperature (0…40 °C) and humidity (0…100 %rH) indoors. The measured value is transmitted wireless to Omnio thermostat actuators and gateways. The RTF160 is characterised by its excellent long-term stability and thanks to the built in solar cell it is

Omnio flush-mounted multi switching actuator 2-channels UPS230/12

The Omnio flush-mounted multi switching actuator 2-channels UPS230/12 is a device for switching electrical loads. Its two potential free outputs are able to be actuated from up to 50 Omnio radio transmitters. Each transmitter can be programmed with one out of twenty different functions such as switch, push-button, staircase lighting, step-switch (AW20), time controlled switch

Omnio weather evaluation unit XFJ

The Omnio weather evaluation unit XFJ is able to convert the captured weather data into EnOcean telegrams. This way blinds can be pilot-controlled and protected against thunderstorms. The following individual signals are available: Channel 1: Weather raw data for higher-level systems according to EEP A5-13-01… 06. Channel 2: Alarm due to failure of the weather

CO2-Sensor

The CO2-sensor is a wired radio sensor to capture the concentration of carbon dioxide (400…2550 ppm) in the air. The measured values are transmitted wireless to Omnio gateways. It is particularly used to control the air quality indoors in offices, schools, hotels and residential premises. EnOcean Equipment Profile (EEP) A5-09-04.

Omnio blind cable actuator 1-channel KXJ230/12

The blind cable actuator 1-channel KXJ230/12 is a device to control 230 V~ tubular motors of blinds, sun blinds, awnings, sliding gates or garage doors. Its two interlocked outputs are able to regulate one drive and can be actuated from up to 50 Omnio radio transmitters. This allows the exact positioning of the blinds and

Omnio DIN rail mounted blind actuator 4-channels REGJ12/04

The Omnio DIN rail mounted blind actuator 4-channels REGJ12/04M is a device to control 230 V~ tubular motors of blinds, sun blinds, awnings, sliding gates or garage doors. Its eight potential free interlocked outputs are able to regulate four drives and these can be actuated from up to 50 Omnio radio transmitters. This allows the

alphaEOS Guard

alphaEOS Guard warns you from fires through optical detection using the scattered light principle. Once a fire is detected, a loud signal is broadcast in an 0,5 second interval. Together with the alphaEOS system, a warning message is also sent to your smartphone.

Oil-Water Warning Device ÖWWG 3

Applications For visual and audible alarms if liquids with a flash point of > 55 °C are detected in, for example, oil storage rooms, drip pans, inspection ducts, ducts, protective pipes, manholes, pipes and cellars. Suitable for the following media: water, fuel oil, diesel fuel or low-viscosity lubricating oils, motor oils, hydraulic oils, vegetable oils

Oil-Water Warning Indicator ÖWU

Application For visual and audible alarms if liquids with a flash point of > 55 °C are detected. Suitable for the following media: water, fuel oil, diesel fuel or low-viscosity lubricating oils, motor oils, gearbox oils or hydraulic oils, vegetable oils and transformer oils. Description Alarm unit in wall mounting housing for early detection of

Vacuum leak detector Eurovac

Application Class I vacuum type leak detector according to EN 13160 for safe monitoring of double-walled tanks and single-walled tanks with inner lining for the storage of water-polluting liquids with a flash point > 55 °C as well as AdBlue® (urea solution 32.5 %) according to DIN 70070. The broad voltage range (AC 100–240 V)