Wireless smoke alarm ASD 10

For detection of fumes and smoke gas in living spaces. Audible alarm when a defined smoke concentration is exceeded.

Micropelt iTRV – self-powered radiator valve actuator (MVA-004)

NodOn Indoor Temperature & Humidity sensor

Measure and control the temperature and the humidity from a wireless and battery-less sensor Compatible with the EnOcean® worldwide Smart Home & Smart Building protocol, this EnOcean® Temperature & Humidity Sensor will check the temperature and the humidity of the room every 100sec, and will feedback it to your Home Automation Gateway or supervision system

EnOcean Smart Repeater

A cost-effective way to transmit EnOcean sensor signals over greater distances or around obstructions within a building Our wireless smart repeater is a cost-effective way to increase the range of your smart devices, allowing them to transmit data over a larger distance or where obstructions occur. Depending on the configuration and the building, repeaters can

Gateway KNX ENO 636 secure

The KNX ENO 636 secure device serves as a bidirectional gateway between EnOcean wireless devices and the KNX bus. With this device, commands and measured values from EnOcean wireless sensors can be transmitted to the KNX bus, for example to control KNX actuators. EnOcean wireless actuators can also be controlled via KNX. The KNX ENO

Gateway KNX ENO 634

The unit KNX ENO 634 serves as a bidirectional gateway between EnOcean radio devices and the KNX/EIB bus. With this device, commands and measured values of EnOcean wireless sensors can be transferred to the KNX bus, for example, to control KNX actuators. Also EnOcean wireless actuators can be controlled via KNX. For EnOcean sensors the

Gateway KNX ENO 632

The unit KNX ENO 632 serves as a bidirectional gateway between EnOcean radio devices and the KNX bus. With this device, commands and measured values of EnOcean wireless sensors can be transferred to the KNX bus, for example, to control KNX actuators. Also EnOcean wireless actuators can be controlled via KNX. For EnOcean sensors the

Gateway KNX ENO 630

The unit KNX ENO 630 serves as a unidirectional gateway between EnOcean radio devices and the KNX/EIB bus. With this device, commands and measured values of EnOcean wireless sensors can be transferred to the KNX bus, for example, to control KNX actuators.For EnOcean sensors the device is based on the so-called EnOcean Equipment Profiles (EEP).

STM 32xJ – Wireless Sensor Module

The extremely power saving RF transmitter module STM 32x/ STM 429J of EnOcean enables the realization of wireless magnet contact sensor. Powered by a solar cell it works absolutely maintenance-free. Technical information and more detailed infromation on: STM 320 (868 MHz for Europe) STM 329 (868 MHz for Europe) STM 320U (902 MHz for North

PTM 21x – Wireless Switch Module

The PTM 21x is a miniaturized batteryless switch module (40 mm x 40 mm x 11.2 mm) which allows the realization of very slim on-wall mountable rocker switches or remote controls. Optionally, one or two switch rockers or up to four push buttons can be realized. See also design data for the PTM module: www.enocean.com/design-data